Setting The Password - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

511 Setting the password

Path: SERVICE MENU / INTERNAL / CONFIGURATION / PASSWORD
Figure 140: PASSWORD settings level
– Start point: PASSWORD settings level
= The first position of the six-character password illuminates.
= On/off key LED illuminates.
1. Run your finger along the touchring until the desired letter or number for the first position of your
password is illuminated.
2. Press the on/off key to accept the letter/number.
= The letter or number is accepted.
= The next password position illuminates.
3. To move to a particular position in the password, select < POS or POS >.
= The corresponding position illuminates.
4. Repeat steps 1 and 2 until the password has been completely entered.
5. Select SAVE to save the password.
= The message SAVED briefly appears.
= Password is saved.
= The previous selection level appears.
Notes
• To delete a position in your password, select the position and then DEL.
• Settings are only saved if SAVE is selected.
• Other letters and special characters can be accessed by running your finger along the touchring.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Configuring the LM-CIRIA control unit
81