594 Bus address icons
Bus address icons can be created for the entry level and displayed in any order.
5941 Adding bus address icons
Note
• If no more icons can be added, the message MAXIMUM NUMBER OF KEYS appears.
Path: SERVICE MENU / INTERNAL / GROUPS / ADD
Figure 116: ADD selection level
– Start point: ADD selection level
1.
Select BUS ADDR.
= SYMBOL settings level appears.
Figure 117: SYMBOL settings level
2.
Run your finger along the touchring until the desired icon appears.
3.
Select NEXT.
= On/off key LED illuminates.
= NAME settings level appears.
= The next available position in the default building service name illuminates.
Figure 118: NAME settings level
4.
Run your finger along the touchring until the desired letter or number for the desired position in the
name is illuminated.
5.
Press the on/off key to accept the letter/number.
= The letter or number is accepted.
= The next position illuminates.
6.
To move to a particular position in the name, select < POS or POS >.
= The corresponding position illuminates.
7.
Repeat steps 4 and 5 until the name has been completely entered.
8.
Select NEXT.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Configuring the LM-CIRIA control unit
66