Configuring The Lm-Zsq Sequencer; Creating Scene Sequences; Sequence Selection Level; Stop Time Settings Level - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

69 Configuring the LM-ZSQ sequencer

You can configure scene sequences to be automatically carried out depending on the time and room
conditions. The LM-CIRIA control unit enables configuration to be written to the external LM-ZSQ se-
quencer. These scene sequences are executed by the LM-ZSQ sequencer.

691 Creating scene sequences

Note
• A maximum of 20 scene sequences can be created. To completely configure a scene sequence,
following all of the instructions in this section.
6911 Defining general settings
Path: SERVICE MENU / EXTERNAL / LM-ZSQ
Figure 159: SEQUENCE selection level
Setting the start time
– Start point: SEQUENCE selection level
1. To create the first scene sequence, go directly to step 2. To add a scene sequence, select NEXT
SEQUENCE until a sequence appears in the header with the number --.
2. Run your finger along the touchring until the desired sequence number appears. This is also the
number of the start scene.
3. Select EDIT.
= START TIME settings level appears.
Figure 160: START TIME settings level
4. Select HOUR.
= HOUR illuminates.
5. Run your finger along the touchring until the desired number appears.
6. Select MINUTE.
= MINUTE illuminates.
7. Run your finger along the touchring until the desired number appears.
8. Select SAVE to save the settings.
= The message SAVED briefly appears.
= Scene sequence start time is saved.
= STOP TIME settings level appears.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Commissioning the field level
102