Building Service Icons (Manual) - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

592 Building service icons (manual)

Building service icons can be created for the entry level and displayed in any order. This section
describes how to create icons manually. Section
describes how to create building service icons automatically.
5921 Adding building service icons
Note
• If no more icons can be added, the message MAXIMUM NUMBER OF KEYS appears.
Path: SERVICE MENU / INTERNAL / OPERATION / ADD
Figure 93: ADD selection level
– Start point: ADD selection level
1. Select BUILDING SERVICE.
= SYMBOL settings level appears.
Figure 94: SYMBOL settings level
2. Run your finger along the touchring until the desired icon appears.
3. Select NEXT.
= On/off key LED illuminates.
= NAME settings level appears.
= The next available position in the default building service name illuminates.
Figure 95: NAME settings level
4. Run your finger along the touchring until the desired letter or number for the desired position in the
name is illuminated.
5. Press the on/off key to accept the letter/number.
= The letter or number is accepted.
= The next position illuminates.
6. To move to a particular position in the name, select < POS or POS >.
= The corresponding position illuminates.
7. Repeat steps 4 and 5 until the name has been completely entered.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Configuring the LM-CIRIA control unit
5.9.5 Group and building service icons (automatic)-
56