Number Settings Level - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

= The next position illuminates.
6. To move to a particular position in the name, select < POS or POS >.
7. Press the on/off key to accept the letter/number.
= The corresponding position illuminates.
8. Repeat steps 4 and 5 until the name has been completely entered.
Note
• To delete a letter or number, move to that position and then select DEL.
9. Select NEXT.
= NUMBER settings level appears.
= Option is illuminated.
Figure 84: NUMBER settings level
10. Run your finger along the touchring until the desired number appears.
11. Select NEXT.
= TYPE settings level appears.
= Option is illuminated.
Figure 85: TYPE settings level
12. Run your finger along the touchring until the desired building service type appears.
13. Select NEXT.
= FADE settings level appears.
= Option is illuminated.
Figure 86: FADE settings level
14. Run your finger along the touchring until the desired number appears.
15. Select SAVE to save the settings.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Configuring the LM-CIRIA control unit
51