Assigning The Address - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

54 Assigning the address

Path: SERVICE MENU / INTERNAL / CONFIGURATION / MY ADDRESS
Figure 70: MY ADDRESS settings level
– Start point: MY ADDRESS settings level
1. Select ROOM to assign the room address.
= ROOM illuminates.
2. Run your finger along the touchring until the desired number appears.
3. Repeat steps 1 and 2 for the group and bus addresses.
4. Select SAVE to save the settings.
= Room, group and bus addresses are saved.
= The previous selection level appears.
Parameter
ROOM
GROUP
BUS ADDR.
Table 2: MY ADDRESS setting options
Notes
• The room, group and bus addresses for the LM-CIRIA control unit must be taken from the system
addressing scheme.
• While a number is being selected with the touchring, the number previously saved for that address
remains illuminated, so that it is always possible to see which address is currently assigned
to the LM-CIRIA control unit.
• If the LM-CIRIA control unit is assigned a group address of 0, all groups in the room can be
operated. If the LM-CIRIA control unit is assigned a group address (e.g. 1), only this group can be
operated.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Configuring the LM-CIRIA control unit
Value range
--; 0 – 99
0 – 99
1 – 99
Factory setting
--
0
0
39