Group And Building Service Icons (Automatic); Status Display - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

595 Group and building service icons (automatic)

Group and building service icons for the entry level can be automatically created. This section de-
scribes how to create icons automatically through the LM-CIRIA control unit. Sections
service icons (manual)
and
5951 Recreating icons
Note
• To configure the group and building service icons, it is recommended to commission the field level
first (see Section 6
Path: SERVICE MENU / INTERNAL / CONFIGURATION / SYMBOL BUILD-UP
Figure 128: SYMBOL BUILD-UP settings level
– Start point: SYMBOL BUILD-UP settings level
= MODE illuminates.
1. Run your finger along the touchring until ALL SYMBOLS NEW appears.
2. Select START.
= Selection confirmation appears.
3. Select YES.
= The data for all addresses and for the building service type on the LM-Bus are imported.
= The status display appears until all addresses are imported.
Figure 129: Status display ... IN PROGRESS ....
= When the data for all addresses and for the building service types have been imported, the previ-
ous selection level appears.
MODE parameter
ALL SYMBOLS NEW
EXTEND SYMBOLS
Table 26: MODE setting options
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
5.9.3 Group icons (manual)
Commissioning the field
All addresses on the LM-Bus are imported. The existing group
and building service icons are written over.
The list of existing group and building service icons is
expanded. The existing icons remain unaffected.
Configuring the LM-CIRIA control unit
describe how to create icons manually.
level).
Description
5.9.2 Building
71