Stop Scene Settings Level - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

6914 Configuring stop scenes
Note
• In order to configure the stop scene, the SCENE parameter must be set to - - after the most recent
scene has been fully configured. Select SAVE to access the STOP SCENE settings level.
Path: SERVICE MENU / EXTERNAL / LM-ZSQ
Figure 178: NEXT SCENE settings level
– Start point: NEXT SCENE settings level for the most recently configured scene
1. Select SCENE.
= SCENE illuminates.
2. Run your finger along the touchring until -- appears.
3. Select SAVE to save the settings.
= The message SAVED briefly appears.
4. Select NEXT STEP.
Figure 179: STOP SCENE settings level
= STOP SCENE settings level appears.
5. Select SCENE.
= SCENE illuminates.
6. Run your finger along the touchring until the desired number appears.
7. Select SAVE to save the setting.
= The message SAVED briefly appears.
= Stop scene is saved.
= FADE - TYPE settings level appears.
Notes
• Settings are only saved if SAVE is selected.
• To create a new sequence directly (without saving), select NEXT SEQUENCE.
Parameter
SCENE
Table 75: SCENE setting options
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Commissioning the field level
Value range
0 – 20
114