Configuring The On/Off Key; Assigning A Presence Or Absence Scene - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

56 Configuring the on/off key

The behaviour of the on/off key can be adapted to suit individual requirements. You can configure
which presence and absence scenes are recalled at which fade speed and which building service type
is controlled using the on/off key.

561 Assigning a presence or absence scene

Path: SERVICE MENU / INTERNAL / CONFIGURATION / SCENE OF KEY
Figure 74: SCENE OF KEY settings level
– Start point: SCENE OF KEY settings level
1. Select PRESENCE.
= PRESENCE illuminates.
2. Run your finger along the touchring until the desired number appears.
3. Select SAVE to save the setting.
= Presence scene is saved.
= The previous selection level appears.
4. To assign an absence scene, carry out steps 1–3, but select ABSENCE instead.
Notes
• Settings are only saved if SAVE is selected.
• Selecting SAVE automatically saves all values displayed on the touchscreen.
Parameter
PRESENCE
ABSENCE
Table 8: SCENE OF KEY setting options
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Configuring the LM-CIRIA control unit
Value range
1 – 20
0 – 20
Factory setting
1
0
43