Adjusting The Lighting Throughout The Room Using Building Service Icons - Zumtobel LUXMATE CIRIA Instructions For Start-Up And Use

421 Adjusting the lighting throughout the room using building service icons

– Start point: entry level
1. Touch the navigation buttons until the building service icons are displayed.
= Building service icons are displayed.
Figure 22: Building service icons
2. Select the desired building service icon, e.g. BRIGHTNESS.
= Settings level appears.
Figure 23: BRIGHTNESS display
3. Run your finger along the touchring.
Figure 24: Touchring
= BRIGHTNESS display appears.
Figure 25: BRIGHTNESS display
= Luminaires are brightened or dimmed.
Notes
• Brighten: run your finger clockwise along the touchring.
• Dim: run your finger anti-clockwise along the touchring.
This is the factory setting; this setting is defined when the system is commissioned (TOUCHRING DIR
parameter).
• Stop lighting adjustment: pause finger or remove from touchring.
• The adjustment of the luminaires is temporary. If the same scene is recalled again, the luminaires
assume their set scene values once more.
LM-CIRIA operating and commissioning manual 2.0 | 06. 2012 | en
Operation
20