Transferring The Desired Files To The Control System - Siemens SINUMERIK 808D ADVANCED Commissioning Manual

Bit Description of the parameters
6 Default value
7 Separator
8 Short parameter text
9 End of variable definition
10 Start of description
11 Parameter name
12 End of description
13 Parameter-specific image
Note
Separators, start and end identifiers must always be entered.
The bits 4, 6, and 13 can be left blank.
If no texts are stored with the $ identifier, three question marks appear in the associated fields on the screen.
Example
//CN1(CYCLE100)
(R/0 99999.999//$83020)[DIA]
(R/0 99999.999//$83021)[DIAF]
(R/-9999.999 99999.999//$83022)[STAP]
(R/-9999.999 99999.999//$83023)[ENDP]
(R/0 99999.999//$83024)[MID]
(R/0 99999.999//$83025)[UX]
(I/*0 1 2/0/$83026)[MACH]/B CN1
(R/1 99999.999/1/$83027)[VRT]
M17
13.4.7

Transferring the desired files to the control system

Proceed as follows to transfer the required files to the control system.
Prerequisite: A USB memory stick which contains all required files is inserted into the USB interface at the front of the PPU.
Transferring the user cycle file
+
Commissioning Manual
01/2017
1. Select the system data operating area.
2. Open the USB storage directory through the following softkey operations:
→
3. Select the desired user cycle file (for example, CYCLE100.SPF) and then press this softkey
to copy the file.
4. Press this softkey to open the user cycle directory.
5. Press this softkey to paste the file.
Entry
Value is missing in the cycle if no entry is made.
/
$ + the identifier (the short description of the selected
parameter, which will display in the upper left corner of the
parameter screen; defined in the extended user text file)
)
[
Text preceding the input field; a maximum of five charac-
ters in length
]
/B + bmp file name (without file extension)
281