Analog Spindle Interface - X54, Spindle Encoder Interface - X60 - Siemens SINUMERIK 808D ADVANCED Commissioning Manual

4.2.12

Analog spindle interface - X54, spindle encoder interface - X60

Interface X54 is for connecting the PPU to the inverter or servo spindle drive. Interface X60 is for connecting the PPU to the
spindle encoder.
Pin assignment - X54
Type Sub-D, 9-pin, female
Cable Max. length: 10 m
Illustration Pin
1
2
3
4
5
6
7
8
9
Pin assignment - X60
Type Sub-D, 15-pin, female
Cable Type: encoder cable
Max. length: 10 m
Illustration Pin
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
Commissioning Manual
01/2017
Signal Comment
AO Analog voltage
- not assigned
- not assigned
- not assigned
SE1 Analog drive enable (contact: electrically isolated n.o. contact)
SE2 Analog drive enable (contact: electrically isolated n.o. contact)
- not assigned
- not assigned
AGND Ground
Signal Comment
- Not assigned
- Not assigned
- Not assigned
+5 V +5 V power supply
- Not assigned
+5 V +5 V power supply
M Ground
- Not assigned
M Ground
Z Zero mark
Z_N Zero mark, negative
B_N Track B, negative
B Track B
A_N Track A, negative
A Track A
99