Siemens SINUMERIK 808D ADVANCED Commissioning Manual page 189

Name Type
Tm_Chg WORD
T_1 BOOL
T_2 BOOL
T_3 BOOL
T_4 BOOL
Parity BOOL
Strobe BOOL
OVload BOOL
P_Indx BOOL
T_key BOOL
Outputs
Name Type
T_cw BOOL
T_ccw BOOL
Magent BOOL
T_LED BOOL
ERR1 BOOL
ERR2 BOOL
ERR3 BOOL
ERR4 BOOL
ERR5 BOOL
Assigned global variables
T_CURRENT VD14000064
T_cw_m M156.0
T_ccw_m M156.1
T_P_INDX MD160
T_DES M164
T_DIR M168.0
T_POS M168.1
T_LOCK M168.2
T_MAG M168.3
Relevant PLC machine data
No. Unit
14510 [20] -
14510 [21] 0.1 s
14510 [22] 0.1 s
14512 [17].0 -
14512 [21].1 -
Commissioning Manual
01/2017
Description
Tool change monitor time (unit: 0.1s)
T code A
T code B
T code C
T code D
Parity bit
Tool on position signal
Turret motor overload (NC)
Turret pre-indexing sensor
Manual key for tool change
Description
Turret CW rotation output
Turret CCW rotation output
Solenoid for clamping
Display for tool changing
Error1: turret motor overload
Error2: programmed tool no. > max tool no.
Error3: max tool no. setting error
Error4: not able to find pre-indexing signal in expected time
Error5: not able to lock in expected time
Current tool (retentive data)
Position marking for turret CW rotation
Position marking for turret CCW rotation
Monitoring the tool change buffer zone in JOG mode
Desired tool number
Direction of adjacent tool change
Turret tool positioning finished
Turret clamping command
Turret magnetic clamping
Description
Max. tool number (4 or 6)
Turret clamping time
Monitoring time for tool searching
Activating the turret function of a turning machine
Switch of the I/O interface (0: set I0.0 to I2.7/Q0.0 to Q1.7 as the standard I/O wiring in
the default PLC; 1: set I6.0 to I8.7/Q4.0 to Q5.7 as the standard I/O wiring in the default
PLC)
189