Siemens SINUMERIK 808D ADVANCED Commissioning Manual page 462

Display Example
P.ara
Data
Func
Addr
Jog
Save
defu
dr--sd
sd--dr
Update
r xxx
r -xxx
T x.x
T -x.x
DCxxx.x
run
Con
462
Description
Editable parameter group
Read-only parameter group
Function group
Set Drive Bus address
Jog function
Save data in drive
Restore drive to default settings
Save data from drive to SD card
Upload data from SD card to drive
Update firmware
Actual speed (positive direction)
Actual speed (negative direction)
Actual torque (positive direction)
Actual torque (negative direction)
Actual DC link voltage
The motor is running
The Drive Bus communication
between the NC and the servo
drive is established. In this case,
the BOP is protected from any
operations except clearing alarms
and acknowledging faults.
Remarks
The dot means that at least one parameter
has been changed without saving
-
See Section "Auxiliary functions (Page 466)".
See Section "Setting Drive Bus address
(Page 467)".
See Section "Jog (Page 467)".
See Section "Saving parameter set in drive
(RAM to ROM) (Page 468)".
See Section "Setting parameter set to default
(Page 468)".
See Section "Transferring data (drive to SD
card) (Page 468)".
See Section "Transferring data (SD card to
drive) (Page 469)".
See Section "Updating firmware (Page 469)".
-
-
-
-
-
-
-
Commissioning Manual
01/2017