Subroutine 43 - Meas_Jog (Measurement In Jog Mode) - Siemens SINUMERIK 808D ADVANCED Commissioning Manual

Assigned global variables
SP_B_CMD
T11
Relevant PLC machine data
No.
14510 [13]
14512 [19].1
Example for calling subroutine 42
6.6.17

Subroutine 43 - MEAS_JOG (measurement in JOG mode)

Purpose
Subroutine 43 is used to process the measuring probe signal and realize the "measuring in JOG mode" function. You can
use this subroutine to calibrate the probe and measure a tool.
The precondition for calling this subroutine is to call subroutine MCP_NCK (SBR37) in the main program. The "measuring in
JOG mode" function is automatically deactivated if you have changed the operating mode when the function becomes
active.
Local variable definition
Inputs
Name
T_ACT
Assigned global variables
MEAS_OPAUT
CHL_HMI
NO_KEY
FDI_MEASJOG
ON_MEASJOG
PROBE_ON
JOG_MEASJOG
AUT_MEASJOG
CHL_MEASJOG
KEY_MEASJOG
RES_MEASJOG
ESC_MEASJOG
DRY_MEASJOG
SBL_MEASJOG
178
BOOL Spindle braking command
TIMER Spindle braking timer
Type Description
BOOL Spindle braking duration (unit: 0.1 s)
BOOL Selection of spindle braking function (1: enabled; 0: forbidden)
Type Description
DWORD Transfer the active tool into interface
M240.0 Measuring in AUTO mode
M240.2 From HMI signals: mode changes during measurement
M240.3 No JOG key available for the axes
M240.5 Meas_JOG forbidden for feed
M240.6 Meas_JOG activated
M240.7 Probe signal released
M241.0 Operating mode manually output to Meas_JOG
M241.1 Operating mode manually output to Meas_JOG
M241.2 Operating mode change forbidden to Meas_JOG
M241.3 JOG key Meas_JOG
M241.4 Reset Meas_JOG
M241.5 Interrupt Meas_JOG
M241.6 Dry run Meas_JOG
M241.7 Single block Meas_JOG
Commissioning Manual
01/2017