Connecting With Plc Programming Tool - Siemens SINUMERIK 808D ADVANCED Commissioning Manual

/
WARNING
Death, severe personal injury and/or property damage due to improper firewall configuration
Improper firewall configuration may cause network security risks, for example, data leakage, virus invasion, and hacker
attack. This may lead to incorrect parameterization or machine malfunction, which in turn can result in death, severe
injuries and/or property damage.
Do not use the control system inside a network infrastructure without an additional security product.
•
You must make sure you disable all ports not needed in the firewall configuration.
•
2.2.2.2

Connecting with PLC Programming Tool

Note
Before connecting PLC Programming Tool, make sure you enable the communication port 102 on the HMI. For more
information about enabling the communication ports, see Section "Configuring the firewall (Page 43)".
Connecting via the Ethernet interface
You can establish a connection between the control system and a computer installed with PLC Programming Tool via the
Ethernet interface (X130). The following Ethernet connections are possible:
● Direct connection: connecting the control system directly to a computer
● Network connection: integrating the control system into an existing Ethernet network
Establishing a direct connection
Proceed through the following steps to establish a direct connection:
+
44
The window below shows three configurable ports which are disabled by default:
4. Select the desired communication port with cursor keys and press either of these keys to
enable it.
5. Press this softkey to confirm your settings.
1. Connect the control system with the computer using an Ethernet cable.
2. Select the system data operating area on the PPU.
3. Press this key to view the extended softkeys.
4. Set up a direct connection on the control system through the following softkey operations:
→
The following dialog box appears on the screen:
→
Commissioning Manual
01/2017