Siemens SINUMERIK 808D ADVANCED Commissioning Manual page 429

Par. No. Name
P43 Brake close speed while
motor operation
When motor speed exceeds 30 rpm and the drive generates an alarm, if, within the specified brake close time
(P42), the actual motor speed becomes smaller than the P43 setpoint, brake is closed when the actual speed
reaches the speed P43 sets.
P44 Drive enable time after the
brake close
When motor speed is lower than 30 rpm, the drive remains enabled within the time period set by P44 after
brake close.
P46 JOG speed
This parameter specifies the motor speed in JOG mode.
P47 Ramp-up/-down time con-
stant
This parameter defines the time period when the motor ramps up from 0 rpm to 2,000 rpm or ramps down from
2, 000 rpm to 0 rpm in JOG mode.
P99 Reserved for Siemens internal use only
Note
For parameters with an asterisk (*), the values in brackets are the second default values. For details, see Section "Function
menu".
Display data (read-only)
Data Name
no.
D10 Torque setpoint
1)
D11 Actual value of the
1)
torque
D12 Actual value of the
1)
phase current
D20 Motor speed setpoint
D21 Actual motor speed
D30 Position revolution set-
point
D31 Position angle setpoint
D32 Actual position revolu-
tions
D33 Actual position angle
D34 Position deviation angle
D50 Digital input signal
2)
Commissioning Manual
01/2017
Range Default
20-2000 100
20-2000 600
0-2000 200
0.0 – 4.0
10.0
Data Unit
format
Decimal Nm
Nm
A
Integer RPM
RPM
Motor revo-
lutions
Increments
(10000/r)
Motor revo-
lutions
Increments
(10000/r)
Increments
(10000/r)
Bit Bits in hex
Increment
20
10
10
0.1
Data Display example
group
Current
Speed -
Position -
I/O
Unit Effective
r/min Power on
ms Power on
rpm Immediately
s Power on
429