Synchronizing Drive Data Files Between Nc And Drive (Ppu161.3 And Ppu160.2 Only) - Siemens SINUMERIK 808D ADVANCED Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
5.2
Synchronizing drive data files between NC and drive (PPU161.3 and
PPU160.2 only)
Note
This function is available on the PPU161.3 and PPU160.2 only.
The NC always compares its data backup with the drive data upon every startup.
● If no data backup files can be found, the NC creates a new backup file automatically with the following message
displaying on the screen:
● If the drive data differs from the NC data backup, data synchronization is required for synchronizing the drive data files
between the NC and the drives.
Operating sequence
Commissioning Manual
01/2017
1.
Press this softkey to enter the setting window when the following data synchronization dia-
log box appears.
Note: a password input field appears in this dialog if you have not set an access level on the
control system. For more information, see Section "Setting the password (Page 144)".
If you cancel the data synchronization with the following softkey, this dialog appears again
on next NC startup.
2.
Select a drive for which you desire to perform the data synchronization.
3.
Press this key to choose a synchronization method for the selected drive.
4.
Press this softkey to confirm your settings and start the data synchronization.
143
Advertisement
Table of Contents
