Configuring The Network Drive - Siemens SINUMERIK 808D ADVANCED Commissioning Manual
Hide thumbs
Also See for SINUMERIK 808D ADVANCED:
- Diagnostic manual (566 pages) ,
- Parameter manual (524 pages) ,
- Operating instructions manual (498 pages)
Table of Contents
Advertisement
10.2
Configuring the network drive
A connected network drive allows you to access a shared directory on your computer from the control system. The network
drive functions based on the Ethernet connection between the control system and a computer. For more information about
how to establish an Ethernet connection, see Section "Network configuration (Page 251)".
Creating and connecting a network drive
Proceed as follows to create and connect a network drive:
252
Note: make sure this vertical softkey is not selected.
6.
Configure the network as required in the following window:
You can configure the DHCP with this key.
Note: if you select "No" for DHCP, you must enter the IP address (which must belong to the
same network as that of your PC) and subnet mask manually.
7.
Press this softkey to save the configuration. If you select "Yes" for DHCP, you also need to
restart the control system to activate the network configuration.
1.
Share a directory on your local disk on your computer.
2.
Select the program management operating area.
3.
Press this softkey to go to the network drive directory.
4.
Press this softkey to go to the window for configuring the network drives.
5.
Press this key to select a drive identifier: N1, N2, or N3.
Commissioning Manual
01/2017
Advertisement
Table of Contents
