Voice Mail Parameters - AudioCodes Mediant 600 User Manual

Parameter

52.11.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Web/EMS: Voice Mail
Interface
[VoiceMailInterface]
Web: Enable VoiceMail
URI
EMS: Enable VMURI
[EnableVMURI]
User's Manual
user or for the endpoint telephone number.
Note: These symbols can always be used as the first digit of a
dialed number even if you disable this parameter.
Voice Mail Parameters
Enables the device's Voice Mail application and determines the
communication method used between the PBX and the device.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)

[7] IP2IP = The device's IP-to-IP application is used for
interworking between an IP Voice Mail server and the device. This
is implemented for sending unsolicited SIP NOTIFY messages
received from the Voice Mail server to an IP Group (configured
using the NotificationIPGroupID parameter).

[8] ETSI = Euro ISDN, according to ETS 300 745-1 V1.2.4, section
9.5.1.1. Enables MWI interworking from IP to Tel, typically used for
BRI phones.
Note: To disable voice mail per Trunk Group, you can use a Tel
Profile with the EnableVoiceMailDelay parameter set to disabled (0).
This eliminates the phenomenon of call delay on Trunks not
implementing voice mail when voice mail is enabled using this global
parameter.
Enables the interworking of target and cause for redirection from Tel
to IP and vice versa, according to RFC 4468.

[0] Disable (default)

[1] Enable
Upon receipt of an ISDN Setup message with Redirect values, the
device maps the Redirect phone number to the SIP 'target' parameter
and the Redirect number reason to the SIP 'cause' parameter in the
Request-URI.
Redirecting Reason
Unknown
User busy
No reply
Deflection
Unconditional
716
Mediant 600 & Mediant 1000
Description
Description
>> SIP Response Code
>> 404
>> 486
>> 408
>> 487/480
>> 302
Document #: LTRT-83313