Serial Parameters - AudioCodes Mediant 600 User Manual

Parameter
SNMP V3 Users Table
Web/EMS: SNMP V3 Users
[SNMPUsers]

52.2.5 Serial Parameters

The RS-232 serial parameters are described in the table below.
Parameter
[DisableRS232]
EMS: Baud Rate
[SerialBaudRate]
EMS: Data
[SerialData]
EMS: Parity
[SerialParity]
EMS: Stop
User's Manual
can access the device.

Trusted managers can work with all community strings.
This parameter table defines SNMP v3 users. The format of this
parameter is as follows:
[SNMPUsers]
FORMAT SNMPUsers_Index = SNMPUsers_Username,
SNMPUsers_AuthProtocol, SNMPUsers_PrivProtocol,
SNMPUsers_AuthKey, SNMPUsers_PrivKey,
SNMPUsers_Group;
[\SNMPUsers]
For example:
SNMPUsers 1 = v3admin1, 1, 0, myauthkey, -, 1;
The example above configures user 'v3admin1' with security level
authNoPriv(2), authentication protocol MD5, authentication text
password 'myauthkey', and ReadWriteGroup2.
Note: For a description of this table, see 'Configuring SNMP V3
Users' on page 88.
Serial Parameters
Enables the device's RS-232 (serial) port.

[0] = (Default) Enabled

[1] = Disabled
The RS-232 serial port can be used to change the networking
parameters and view error/notification messages. For how to establish
a serial communication with the device, refer to the Installation Manual.
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 baud rate.
The valid values include the following: 1200, 2400, 9600, 14400, 19200,
38400, 57600, or 115200 (default).
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 data bit.

[7] = 7-bit

[8] = (Default) 8-bit
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 polarity.

[0] = (Default) None

[1] = Odd

[2] = Even
Note: For this parameter to take effect, a device reset is required.
Defines the RS-232 stop bit.
626
Mediant 600 & Mediant 1000
Description
Description
Document #: LTRT-83313