User's Manual
18
Coders and Profiles
This section describes configuration of the coders and SIP profiles parameters.
18.1
Configuring Coders
The Coders page allows you to configure up to 10 voice coders for the device. Each coder
can be configured with packetization time (ptime), bit rate, payload type, and silence
suppression. The first coder configured in the table has the highest priority and is used by
the device whenever possible. If the remote side cannot use the first coder, the device
attempts to use the next coder in the table, and so on.
Notes:
Version 6.6
•
A specific coder can only be configured once in the table.
•
If packetization time and/or rate are not specified, the default is applied.
•
Only the packetization time of the first coder in the coder list is declared
in INVITE/200 OK SDP, even if multiple coders are defined.
•
The device always uses the packetization time requested by the remote
side for sending RTP packets. If not specified, the packetization time is
assigned the default value.
•
The value of several fields is hard-coded according to common
standards (e.g., payload type of G.711 U-law is always 0). Other values
can be set dynamically. If no value is specified for a dynamic field, a
default is assigned. If a value is specified for a hard-coded field, the
value is ignored.
•
If silence suppression is not configured for a coder, the settings of the
EnableSilenceCompression parameter is used.
•
The G.722 coder provides Packet Loss Concealment (PLC) capabilities,
ensuring higher voice quality.
•
Both GSM-FR and MS-GSM coders use Payload Type 3. When using
SDP, it isn't possible to differentiate between the two. Therefore, it is
recommended not to select both coders simultaneously.
•
For G.729, it's also possible to select silence suppression without
adaptations.
•
If G.729 is selected and silence suppression is disabled, the device
includes 'annexb=no' in the SDP of the relevant SIP messages. If silence
suppression is enabled or set to 'Enable w/o Adaptations', 'annexb=yes'
is included. An exception to this logic is when the remote gateway is a
Cisco device (IsCiscoSCEMode).
•
For defining groups of coders, which can be assigned to Tel and IP
Profiles, see 'Configuring Coder Groups' on page 242.
•
For information on V.152 and implementation of T.38 and VBD coders,
see 'Supporting V.152 Implementation' on page 168.
•
The Coders table can also be configured using the table ini file
parameter, CodersGroup.
239
18. Coders and Profiles
Mediant 600 & Mediant 1000