AudioCodes Mediant 600 User Manual page 226

2. In the 'Add' field, enter the desired table row index, and then click Add. A new row
appears.
3. Configure the Account parameters according to the table below.
4. Click the Apply button to save your changes.
5. To save the changes, see 'Saving Configuration' on page 494.
6. To perform registration, click the Register button; to unregister, click Unregister. The
registration method for each Trunk Group is according to the setting of the
'Registration Mode' parameter in the Trunk Group Settings page.
Parameter
Served Trunk Defines the Trunk Group ID that you want to register and/or authenticate to a
Group destination IP Group (i.e., Serving IP Group).
CLI: served-trunk-

group
[Account_ServedTr

unkGroup]
Note: This parameter is applicable only to the Gateway application.
Served IP Group Defines the Source IP Group (e.g., IP-PBX) for which registration and/or
[Account_ServedIP authentication is done.
Group]
Note: This parameter is applicable only to the SBC and IP-to-IP applications
(not Gateway application).
Serving IP Group Defines the destination IP Group ID to where the SIP REGISTER requests, if
[Account_ServingI enabled, are sent and authentication is done. The actual destination to where
PGroup] the REGISTER requests are sent is the IP address configured for the Proxy
Set ID that is associated with the IP Group.
Registration occurs only if:


For the Gateway and IP-to-IP applications:


Note: If no match is found in this table for incoming or outgoing calls, the
username and password is taken from the following:


Username Defines the digest MD5 Authentication user name.
[Account_Userna
The valid value is a string of up to 50 characters.
me]
User's Manual
Account Table Parameters Description
For Tel-to-IP calls, the Served Trunk Group is the source Trunk Group
from where the call originated.
For IP-to-Tel calls, the Served Trunk Group is the HuntTrunk Group ID to
which the call is sent.
Gateway application only: The 'Registration Mode' parameter is set to
'Per Account' in the Hunt Group Settings table (see Configuring Hunt
Group Settings on page 293).
The 'Register' parameter in the Account table is set to Yes.
For Tel-to-IP calls, the serving IP Group is the destination IP Group
defined in the Trunk Group Settings table or Outbound IP Routing Table
(see Configuring the Outbound IP Routing Table on page 323).
For IP-to-Tel calls, the Serving IP Group is the 'Source IP Group ID'
defined in the Inbound IP Routing Table (see Configuring the Inbound IP
Routing Table on page 332).
FXS interfaces: Authentication table (see Configuring Authentication)
UserName and Password parameters on the Proxy & Registration page.
226
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313