AudioCodes Mediant 600 User Manual page 621

User's Manual
Parameter
Config
[DisableWebConfig]
[ResetWebPassword]
[ScenarioFileName]
Version 6.6

[0] = (Default) Enables modifications of parameters.

[1] = Web interface is read-only.
When in read-only mode, parameters can't be modified. In addition, the
following pages can't be accessed: 'Web User Accounts', 'Certificates',
'Regional Settings', 'Maintenance Actions' and all file-loading pages
('Load Auxiliary Files', 'Software Upgrade Wizard', and 'Configuration
File').
Notes:

For this parameter to take effect, a device reset is required.

To return to read/write after you have applied read-only using this
parameter (set to 1), you need to reboot your device with an ini file
that doesn't include this parameter, using the AcBootP utility.
Resets the username and password of the primary ("Admin") and
secondary ("User") accounts to their default settings ("Admin" and
"Admin" respectively), and deletes all other users that may have been
configured.

[0] = (Default) Password and username retain their values.

[1] = Password and username are reset.
Notes:

For this parameter to take effect, a device reset is required.

You cannot reset the username and password through the Web
interface (by loading an ini file or on the AdminPage). To reset the
username and password:

BootP: Set this parameter in an ini file and and load it to the
device through BootP (for more information, refer to the
AcBootP Utility User's Guide).

SNMP:
1) Set acSysGenericINILine to
WEBPasswordControlViaSNMP = 1, and reset the device with
a flash burn (set acSysActionSetResetControl to 1 and
acSysActionSetReset to 1).
2) Change the username and password in the
acSysWEBAccessEntry table. Use the following format:
Username acSysWEBAccessUserName: old/pass/new
Password acSysWEBAccessUserCode: username/old/new
Defines the file name of the Scenario file to be loaded to the device.
The file name must have the .dat extension and can be up to 47
characters. For loading a Scenario using the Web interface, see
Loading a Scenario to the Device on page 57.
621
52. Configuration Parameters Reference
Description
Mediant 600 & Mediant 1000