AudioCodes Mediant 600 User Manual page 292

'Configuring Trunk Group Settings' on page 293).
Parameter
Module
[TrunkGroup_Module]
From Trunk
[TrunkGroup_FirstTrunkI
d]
To Trunk
[TrunkGroup_LastTrunkI
d]
Channels
[TrunkGroup_FirstBChan
nel]
[TrunkGroup_LastBChan
nel]
Phone Number
[TrunkGroup_FirstPhone
Number]
Trunk Group ID
[TrunkGroup_TrunkGrou
pNum]
Tel Profile ID
[TrunkGroup_ProfileId]
User's Manual
Trunk Group Table Parameters
Defines the module (i.e., FXS, FXO, PRI, or BRI) for which you want
to define the Trunk Group.
Defines the starting physical Trunk number in the Trunk Group. The
number of listed Trunks depends on the device's hardware
configuration.
Note: This parameter is applicable only to PRI and BRI modules.
Defines the ending physical Trunk number in the Trunk Group. The
number of listed Trunks depends on the device's hardware
configuration.
Note: This parameter is applicable only to PRI and BRI modules.
Defines the device's channels/ports (analog module) or Trunk B-
channels (digital module). To enable channels, enter the channel
numbers. You can enter a range of channels by using the syntax n-m,
where n represents the lower channel number and m the higher
channel number. For example, "1-4" specifies channels 1 through 4.
Notes:

The number of defined channels must not exceed the maximum
number of the Trunk's B-channels.

To represent all the Trunk's B-channels, enter a single asterisk (*).
Defines the telephone number(s) of the channels.
The valid value can be up to 50 characters.
For a range of channels, enter only the first telephone number.
Subsequent channels are assigned the next consecutive telephone
number. For example, if you enter 400 for channels 1 to 4, then
channel 1 is assigned phone number 400, channel 2 is assigned
phone number 401, and so on.
These numbers are also used for channel allocation for IP-to-Tel calls
if the Trunk Group's 'Channel Select Mode' parameter is set to By
Dest Phone Number.
Notes:

If this field includes alphabetical characters and the phone number
is defined for a range of channels (e.g., 1-4), then the phone
number must end with a number (e.g., 'user1').

This field is optional for BRI/PRI interfaces. The logical numbers
defined in this field are used when an incoming PSTN/PBX call
doesn't contain the calling number or called number (the latter
being determined by the ReplaceEmptyDstWithPortNumber
parameter). These numbers are used to replace them.
Defines the Trunk Group ID for the specified channels. The same
Trunk Group ID can be assigned to more than one group of channels.
If an IP-to-Tel call is assigned to a Trunk Group, the IP call is routed
to the channel(s) pertaining to that Trunk Group ID.
The valid value can be 0 to 119.
Assigns a Tel Profile ID to the Trunk Group.
Note: For configuring Tel Profiles, see 'Configuring Tel Profiles' on
page 243.
292
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313