AudioCodes Mediant 600 User Manual page 724

Parameter
ode]
EMS: Bellcore Caller ID
Type One Sub Standard
[BellcoreCallerIDTypeOn
eSubStandard]
EMS: ETSI Caller ID Type
One Sub Standard
[ETSICallerIDTypeOneSu
bStandard]
Web: Asserted Identity
Mode
EMS: Asserted ID Mode
[AssertedIdMode]
Web/EMS: Use Destination
As Connected Number
[UseDestinationAsConne
ctedNumber]
User's Manual
the Caller ID according to the selected Caller ID type.
Notes:

This parameter is applicable only to FXS interfaces.

If this parameter is set to 1 and used with distinctive ringing, the
Caller ID signal doesn't change the distinctive ringing timing.

For this parameter to take effect, a device reset is required.
Determines the Bellcore Caller ID sub-standard.

[0] = (Default) Between rings.

[1] = Not ring related.
Note: For this parameter to take effect, a device reset is required.
Determines the ETSI FSK Caller ID Type 1 sub-standard (FXS only).

[0] = (Default) ETSI between rings.

[1] = ETSI before ring DT_AS.

[2] = ETSI before ring RP_AS.

[3] = ETSI before ring LR_DT_AS.

[4] = ETSI not ring related DT_AS.

[5] = ETSI not ring related RP_AS.

[6] = ETSI not ring related LR_DT_AS.
Note: For this parameter to take effect, a device reset is required.
Determines whether the SIP header P-Asserted-Identity or P-
Preferred-Identity is used in the generated SIP INVITE, 200 OK, or
UPDATE request for Caller ID (or privacy). These headers are used to
present the originating party's Caller ID. The Caller ID is composed of
a Calling Number and a Calling Name (optional).

[0] Disabled = (Default) P-Asserted-Identity nor P-Preferred-Identity
headers are not added.

[1] Add P-Asserted-Identity

[2] Add P-Preferred-Identity
The header used also depends on the calling Privacy (allowed or
restricted). These headers are used together with the Privacy header.
If Caller ID is restricted (i.e., P-Asserted-Identity is not sent), the
Privacy header includes the value 'id' ('Privacy: id'). Otherwise, for
allowed Caller ID, 'Privacy: none' is used. If Caller ID is restricted
(received from PSTN / Tel or configured in the device), the From
header is set to <anonymous@anonymous.invalid>.
The 200 OK response can contain the connected party CallerID -
Connected Number and Connected Name. For example, if the call is
answered by the device, the 200 OK response includes the P-
Asserted-Identity with Caller ID. The device interworks (in some ISDN
variants), the Connected Party number and name from Q.931 Connect
message to SIP 200 OK with the P-Asserted-Identity header. In the
opposite direction, if the ISDN device receives a 200 OK with P-
Asserted-Identity header, it interworks it to the Connected party
number and name in the Q.931 Connect message, including its
privacy.
Enables the device to include the Called Party Number, from outgoing
Tel calls (after number manipulation), in the SIP P-Asserted-Identity
header. The device includes the SIP P-Asserted-Identity header in 180
Ringing and 200 OK responses for IP-to-Tel calls.

[0] Disable (default)
724
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313