Call Forwarding Parameters - AudioCodes Mediant 600 User Manual

52.11.5.3

Call Forwarding Parameters

The call forwarding parameters are described in the table below.
Parameter
Web: Enable Call
Forward
[EnableForward]
Call Forwarding Table
Web: Call Forwarding
Table
EMS: Analog Gateway
Provisioning > Tab: Call
Forward
[FwdInfo]
Call Forward Reminder Ring Parameters
Notes:

These parameters are applicable only to FXS interfaces.

For a description of this feature, see Call Forward Reminder Ring on page 354.
Web/EMS: Enable NRT
Subscription
[EnableNRTSubscripti
on]
Web: AS Subscribe
IPGroupID
[ASSubscribeIPGroupI
D]
User's Manual
Call Forwarding Parameters
Enables the Call Forwarding feature.

[0] Disable

[1] Enable (Default)
For FXS interfaces, the Call Forward table (FwdInfo parameter) must be
defined to use the Call Forward service. The device uses SIP REFER
messages for call forwarding.
Note: To use this service, the devices at both ends must support this
option.
This table parameter configures call forwarding of IP-to-Tel calls (using
SIP 302 response) to other device ports or an IP destination, based on
the device's port to which the call was originally routed.
The format of this parameter is as follows:
[FwdInfo]
FORMAT FwdInfo_Index = FwdInfo_Type, FwdInfo_Destination,
FwdInfo_NoReplyTime, FwdInfo_Module, FwdInfo_Port;
[\FwdInfo]
Where,

Module = Module number, where 1 denotes the module in Slot 1.

Port = Port number, where 1 denotes Port 1 of a module.
For example:

Below configuration forwards calls originally destined to Port 1 of
Module 1 to "1001" upon On Busy:
FwdInfo 0 = 1,1001,30,1,1;

Below configuration forwards calls originally destined to Port 2 of
Module 1 to an IP address upon On Busy:
FwdInfo 1 = 1,2003@10.5.1.1,30,1,2;
Notes:

The indexing of this parameter starts at 0.

For a detailed description of this table, see Configuring Call Forward
on page 397.
Enables endpoint subscription for Ring reminder event notification feature.

[0] Disable (default)

[1] Enable
Defines the IP Group ID that contains the Application server for
Subscription.
The valid value range is 1 to 8. The default is -1 (i.e., not configured).
728
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313