Automatic Dialing Parameters; Direct Inward Dialing Parameters - AudioCodes Mediant 600 User Manual

User's Manual
52.11.5.10

Automatic Dialing Parameters

The automatic dialing upon off-hook parameters are described in the table below.
Parameter
Automatic Dialing Table
Web: Automatic Dialing
Table
EMS: Analog Gateway
Provisioning >
Automatic dialing
[TargetOfChannel]
52.11.5.11

Direct Inward Dialing Parameters

The Direct Inward Dialing (DID) parameters are described in the table below.
Parameter
Web/EMS: DID Wink
[EnableDIDWink]
Version 6.6
Automatic Dialing Parameters
This table parameter defines telephone numbers that are automatically
dialed when a specific FXS or FXO port is off-hooked. The format of this
parameter is as follows:
[TargetOfChannel]
FORMAT TargetOfChannel_Index = TargetOfChannel_Destination,
TargetOfChannel_Type, TargetOfChannel_Module,
TargetOfChannel_Port, TargetOfChannel_HotLineToneDuration;
[\TargetOfChannel]
For example, the below configuration defines automatic dialing of phone
number 911 when the phone connected to Port 1 of Module 1 is off-
hooked for over 10 seconds:
TargetOfChannel 0 = 911, 1, 1, 1 ,10;
Notes:

The first index of this table ini file parameter is 0.

TargetOfChannel_Module is the module number, where 1 denotes the
module in Slot 1.

TargetOfChannel_Port is the port number, where 1 denotes Port 1 on
the module.

This is parameter is applicable only to FXS and FXO interfaces.

For a detailed description of this table, see 'Configuring Automatic
Dialing' on page 394.
DID Parameters
Enables Direct Inward Dialing (DID) using Wink-Start signaling, typically
used for signaling between an E-911 switch and the PSAP.

[0] Disable (default)

[1] Single = The device can be used for connection to EIA/TIA-464B
DID Loop Start lines. Both FXO (detection) and FXS (generation) are
supported:

The FXO interface dials DTMF (or MF) digits upon detection of a
Wink signal, instead of a dial tone.

The FXS interface generates a Wink signal upon detection of an
off-hook state, instead of playing a dial tone.
Example: (Wink) KP I(I) xxx-xxxx ST (Off Hook)
Where:

I = one or two information digits

x = ANI
52. Configuration Parameters Reference
Description
Description
743 Mediant 600 & Mediant 1000