Supplementary Services Parameters; Caller Id Parameters - AudioCodes Mediant 600 User Manual

User's Manual
Parameter
Web: Disconnect Call
Digit Pattern
EMS: Tel Disconnect
Code
[TelDisconnectCode]
Web: Digit To Ignore Digit
Pattern
EMS: Digit To Ignore
[DigitPatternDigitToIgno
re]

52.11.5 Supplementary Services Parameters

This subsection describes the device's supplementary telephony services parameters.
52.11.5.1

Caller ID Parameters

The caller ID parameters are described in the table below.
Parameter
Caller ID Permissions Table
Web: Caller ID
Permissions Table
EMS: SIP Endpoints >
Caller ID
[EnableCallerID]
Caller Display Information Table
Web: Caller Display
Information Table
EMS: SIP Endpoints >
Caller ID
[CallerDisplayInfo]
Version 6.6
Defines a digit pattern that when received from the Tel side, indicates
the device to disconnect the call.
The valid range is a 25-character string.
Defines a digit pattern that if received as Src (S) or Redirect (R)
numbers is ignored and not added to that number.
The valid range is a 25-character string.
Caller ID Parameters
This table parameter enables (per port) Caller ID generation (for FXS
interfaces) and detection (for FXO interfaces).
The format of this parameter is as follows:
[EnableCallerID]
FORMAT EnableCallerID_Index = EnableCallerID_IsEnabled,
EnableCallerID_Module, EnableCallerID_Port;
[\EnableCallerID]
Where,

Module = Module number, where 1 denotes the module in Slot 1.

Port = Port number, where 1 denotes Port 1 of a module.
For example:
EnableCallerID 0 = 1,3,1; (caller ID enabled on Port 1 of Module 3)
EnableCallerID 1 = 0,3,2; (caller ID disabled on Port 2 of Module 3)
Notes:

The indexing of this parameter starts at 0.

For a detailed description of this table, see Configuring Caller ID
Permissions on page 399.
This table parameter enables the device to send Caller ID information
to the IP side when a call is made. The called party can use this
information for caller identification. The information configured in this
table is sent in the SIP INVITE message's From header.
The format of this parameter is as follows:
[CallerDisplayInfo]
FORMAT CallerDisplayInfo_Index = CallerDisplayInfo_DisplayString,
721
52. Configuration Parameters Reference
Description
Description
Mediant 600 & Mediant 1000