Voice Mail Parameters - AudioCodes Mediant 800B User Manual

User's Manual
Parameter
[MaxDigits]
Web: Inter Digit Timeout for
Overlap Dialing [sec]
EMS: Interdigit Timeout (Sec)
CLI: time-btwn-dial-digs
[TimeBetweenDigits]
Web: Enable Special Digits
EMS: Use '#' For Dial
Termination
CLI: special-digits
[IsSpecialDigits]

54.10.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Web/EMS: Voice Mail Interface
CLI: vm-interface
[VoiceMailInterface]
Version 6.8
The valid range is 1 to 49. The default is 5 for analog and 30for
digital.
Notes:

Instead of using this parameter, Digit Mapping rules can be
configured.

Dialing ends when any of the following scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed

Digit map pattern is matched
For analog interfaces: Defines the time (in seconds) that the device
waits between digits that are dialed by the user.
For ISDN overlap dialing: Defines the time (in seconds) that the
device waits between digits that are received from the PSTN or IP
during overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Determines whether the asterisk (*) and pound (#) digits can be used
in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection (refer to
the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note: These symbols can always be used as the first digit of a dialed
number even if you disable this parameter.
Table 54-42: Voice Mail Parameters
Enables the device's Voice Mail application and determines the
communication method between the device and PBX.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific Information
(MSI)

[7] IP2IP = The device's IP-to-IP application is used for
interworking between an IP Voice Mail server and the device.
This is implemented for sending unsolicited SIP NOTIFY
815
54. Configuration Parameters Reference
Description
Description
Mediant 800B Gateway and E-SBC