Voice Mail Parameters - AudioCodes Mediant 1000B User Manual

User's Manual
Parameter
Inter Digit Timeout for
Overlap Dialing
configure voip > gateway
dtmf-supp-service dtmf-and-
dialing > time-btwn-dial-digs
[TimeBetweenDigits]
Enable Special Digits
configure voip > gateway
dtmf-supp-service dtmf-and-
dialing > special-digits
[IsSpecialDigits]

65.10.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Voice Mail Interface
configure voip > gateway voice-mail-
setting > vm-interface
[VoiceMailInterface]
Version 7.2
Analog: Defines the time (in seconds) that the device waits between
digits that are dialed by the user.
ISDN overlap dialing: Defines the time (in seconds) that the device
waits between digits that are received from the PSTN or IP during
overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Determines whether the asterisk (*) and pound (#) digits can be used
in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection (refer to
the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Note:

The symbols can always be used as the first digit of a dialed
number even if you disable the parameter.

The parameter is applicable only to analog interfaces.
Table 65-41: Voice Mail Parameters
Enables the device's Voice Mail application and determines
the communication method between the device and PBX.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific
Information (MSI)

[8] ETSI = Euro ISDN, according to ETS 300 745-1
V1.2.4, section 9.5.1.1. Enables MWI interworking from
IP to Tel, typically used for BRI phones.

[9] NI2= ISDN PRI trunks set to NI-2. This is used for
interworking the SIP Message Waiting Indication (MWI)
NOTIFY message to ISDN PRI NI-2 Message Waiting
Notification (MWN) that is sent in the ISDN Facility IE
message. This option is applicable when the device is
connected to a PBX through an ISDN PRI trunk
configured to NI-2.
Note: To disable voice mail per Trunk Group, you can use a
1119
65. Configuration Parameters Reference
Description
Description
Mediant 1000B Gateway & E-SBC