Configuring Media Realms - AudioCodes Mediant 600 User Manual

User's Manual
Notes:
13.8

Configuring Media Realms

The Media Realm Table page allows you to define a pool of up to 64 SIP media interfaces,
termed Media Realms. Media Realms allow you to divide a Media-type interface, which is
configured in the Multiple Interface table, into several realms, where each realm is
specified by a UDP port range. You can also define the maximum number of sessions per
Media Realm. Once configured, Media Realms can be assigned to IP Groups (see
'Configuring IP Groups' on page 214) or SRDs (see 'Configuring SRD Table' on page 211).
Once you have configured a Media Realm, you can configure it with the following:

Quality of Experience parameters for reporting to AudioCodes SEM server used for
monitoring the quality of calls (see Configuring Quality of Experience Parameters per
Media Realm on page 185)

Bandwidth management (see 'Configuring Bandwidth Management per Media Realm'
on page 188)
Notes:
Version 6.6
•
If the device is not installed with an MPM module and you want the
device to "borrow" DSP channels from the PRI modules, you must set
the EnableIPMediaChannels parameter to 1. This parameter is
automatically enabled when the device is installed with an MPM module.
•
The value of IPMediaChannels_DSPChannelsReserved must be in
multiples of 5.
•
By default, the MPM module is set to the maximum number of IP media
channels. Therefore, there is no need to define it with the
IPmediaChannels parameter.
•
By default, the IPMediaChannels_DSPChannelsReserved parameter for
all PRI modules is set to 0 (i.e., no "borrowing" of IP media channels).
•
If different Media Realms are assigned to an IP Group and to an SRD,
the IP Group's Media Realm takes precedence.
•
For this setting to take effect, a device reset is required.
•
The Media Realm table can also be configured using the table ini file
parameter, CpMediaRealm.
183
13. Media
Mediant 600 & Mediant 1000