AudioCodes Mediant 600 User Manual page 730

Parameter
Web: MWI Server IP
Address
EMS: MWI Server IP
[MWIServerIP]
Web/EMS: MWI Server
Transport Type
[MWIServerTransportT
ype]
Web: MWI Subscribe
Expiration Time
EMS: MWI Expiration
Time
[MWIExpirationTime]
Web: MWI Subscribe
Retry Time
EMS: Subscribe Retry
Time
[SubscribeRetryTime]
Web: Subscription
Mode
[SubscriptionMode]
EMS: ETSI VMWI Type
One Standard
[ETSIVMWITypeOneSt
andard]
EMS: Bellcore VMWI
Type One Standard
[BellcoreVMWITypeOn
eStandard]
User's Manual
entire device, use the parameter SubscriptionMode.
Defines the MWI server's IP address. If provided, the device subscribes to
this IP address. The MWI server address can be configured as a
numerical IP address or as a domain name. If not configured, the Proxy
IP address is used instead.
Determines the transport layer used for outgoing SIP dialogs initiated by
the device to the MWI server.

[-1] Not Configured (default)

[0] UDP

[1] TCP

[2] TLS
Note: When set to 'Not Configured', the value of the parameter
SIPTransportType is used.
Defines the MWI subscription expiration time in seconds.
The default is 7200 seconds. The range is 10 to 2,000,000.
Defines the subscription retry time (in seconds) after last subscription
failure.
The default is 120 seconds. The range is 10 to 2,000,000.
Determines the method the device uses to subscribe to an MWI server.

[0] Per Endpoint = (Default) Each endpoint subscribes separately -
typically used for FXS interfaces.

[1] Per Gateway = Single subscription for the entire device - typically
used for FXO interfaces.
Determines the ETSI Visual Message Waiting Indication (VMWI) Type 1
sub-standard.

[0] = (Default) ETSI VMWI between rings

[1] = ETSI VMWI before ring DT_AS

[2] = ETSI VMWI before ring RP_AS

[3] = ETSI VMWI before ring LR_DT_AS

[4] = ETSI VMWI not ring related DT_AS

[5] = ETSI VMWI not ring related RP_AS

[6] = ETSI VMWI not ring related LR_DT_AS
Note: For this parameter to take effect, a device reset is required.
Determines the Bellcore VMWI sub-standard.

[0] = (Default) Between rings.

[1] = Not ring related.
Note: For this parameter to take effect, a device reset is required.
730
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313