Voice Mail Parameters - AudioCodes Mediant 800B User Manual

Parameter
digits
[IsSpecialDigits]

72.11.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Voice Mail Interface
configure voip > gateway voice-mail-
setting > vm-interface
[VoiceMailInterface]
Enable VoiceMail URI
voicemail-uri
[EnableVMURI]
User's Manual
(refer to the parameter UseDigitForSpecialDTMF).
(Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed
by a user or for the endpoint telephone number.
Note:

The symbols can always be used as the first digit of a
dialed number even if you disable the parameter.

The parameter is applicable only to analog interfaces.
Table 72-43: Voice Mail Parameters
Enables the device's Voice Mail application and determines
the communication method between the device and PBX.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific
Information (MSI)

[8] ETSI = Euro ISDN, according to ETS 300 745-1
V1.2.4, section 9.5.1.1. Enables MWI interworking from
IP to Tel, typically used for BRI phones.

[9] NI2= ISDN PRI trunks set to NI-2. This is used for
interworking the SIP Message Waiting Indication (MWI)
NOTIFY message to ISDN PRI NI-2 Message Waiting
Notification (MWN) that is sent in the ISDN Facility IE
message. This option is applicable when the device is
connected to a PBX through an ISDN PRI trunk
configured to NI-2.
Note: To disable voice mail per Trunk Group, you can use a
Tel Profile with the EnableVoiceMailDelay parameter set to
disabled (0). This eliminates the phenomenon of call delay
on Trunks not implementing voice mail when voice mail is
enabled using this global parameter.
Enables the interworking of target and cause for redirection
from Tel to IP and vice versa, according to RFC 4468.

[0] Disable (default)

[1] Enable
Upon receipt of an ISDN Setup message with Redirect
values, the device maps the Redirect phone number to the
SIP 'target' parameter and the Redirect number reason to
1182
Mediant 800B Gateway & E-SBC
Description
Description
Document #: LTRT-10632