Assigning Cost Groups To Routing Rules - AudioCodes Mediant 600 User Manual

4. Configure the parameters as required. For a description of the parameters, see the
table below.
5. Click Submit; the entry is added to the Time Band table for the relevant Cost Group.
Parameter
Index
[CostGroupTimebands
_TimebandIndex]
Start Time
[CostGroupTimebands
_StartTime]
End Time
[CostGroupTimebands
_EndTime]
Connection Cost
[CostGroupTimebands
_ConnectionCost]
Minute Cost
[CostGroupTimebands
_MinuteCost]

14.2.2.4 Assigning Cost Groups to Routing Rules

Once you have configured your Cost Groups, you need to assign them to routing rules in
the Outbound IP Routing table - see Configuring Outbound IP Routing Table on page
User's Manual
Time Band Table Description
Defines the table index entry.
Defines the day and time of day from when this time band is applicable.
The format is ddd:hh:mm (e.g., sun:06:00), where:

ddd is the day (i.e., sun, mon, tue, wed, thu, fri, or sat)

hh and mm denote the time of day, where hh is the hour (00-23) and
mm the minutes (00-59)
Defines the day and time of day until when this time band is applicable.
For a description of the valid values, see the parameter above.
Defines the call connection cost during this time band. This is added as a
fixed charge to the call.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a decimal).
Defines the call cost per minute charge during this timeband.
The valid value range is 0-65533. The default is 0.
Note: The entered value must be a whole number (i.e., not a decimal).
208
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313
323.