AudioCodes Mediant 600 User Manual page 438


To configure the IP-to-IP Routing table for SAS:
1. In the SAS Configuration page, click the SAS Routing Table
Routing Table page appears.
2. Click Add; the Add Record dialog box appears:
Figure 29-9: Add Record Dialog Box of SAS IP2IP Routing Page
3. Configure the rule according to the table below.
4. Click Submit to apply your changes.
5. To save the changes to flash memory, see 'Saving Configuration' on page 494.
Note:
Parameter
Matching Characteristics
Source Username Prefix
[IP2IPRouting_SrcUser
namePrefix]
User's Manual
The following parameters are not applicable to SAS and must be ignored:
•
'Source IP Group ID'
•
'Destination IP Group ID'
•
'Destination SRD ID'
•
'Alternative Route Options'
SAS IP-to-IP Routing Table Parameters
Defines the prefix of the user part of the incoming SIP dialog's source
URI (usually the From URI). You can use special notations for denoting
the prefix. For example, to denote any prefix, use the asterisk (*) symbol;
to denote calls without a user part in the URI, use the $ sign. For
available notations, see 'Dialing Plan Notation for Routing and
Manipulation' on page 607.
The default is * (i.e., any prefix).
Description
438
Mediant 600 & Mediant 1000
button; the IP-to-IP
Document #: LTRT-83313