AudioCodes Mediant 600 User Manual page 658

Voip media gateways analog & digital lines
Hide thumbs Also See for Mediant 600:
Table of Contents

Advertisement

Parameter
Web: Registration Time
Threshold
EMS: Time Threshold
[RegistrationTimeThres
hold]
Web: Re-register On
INVITE Failure
EMS: Register On Invite
Failure
[RegisterOnInviteFailure
]
Web: ReRegister On
Connection Failure
EMS: Re Register On
Connection Failure
[ReRegisterOnConnecti
onFailure]
Web: Gateway
Registration Name
EMS: Name
[GWRegistrationName]
Web/EMS: Registration
Mode
[AuthenticationMode]
User's Manual
Defines a threshold (in seconds) for re-registration timing. If this
parameter is greater than 0, but lower than the computed re-registration
timing (according to the parameter RegistrationTimeDivider), the re-
registration timing is set to the following: timing set by the Registration
server in the SIP Expires header minus the value of the parameter
RegistrationTimeThreshold.
The valid range is 0 to 2,000,000. The default is 0.
Enables immediate re-registration if no response is received for an
INVITE request sent by the device.
[0] Disable (default)
[1] Enable
When enabled, the device immediately expires its re-registration timer
and commences re-registration to the same Proxy upon any of the
following scenarios:
The response to an INVITE request is 407 (Proxy Authentication
Required) without an authentication header included.
The remote SIP UA abandons a call before the device has received
any provisional response (indicative of an outbound proxy server
failure).
The remote SIP UA abandons a call and the only provisional
response the device has received for the call is 100 Trying
(indicative of a home proxy server failure, i.e., the failure of a proxy
in the route after the outbound proxy).
The device terminates a call due to the expiration of RFC 3261
Timer B or due to the receipt of a 408 (Request Timeout) response
and the device has not received any provisional response for the call
(indicative of an outbound proxy server failure).
The device terminates a call due to the receipt of a 408 (Request
Timeout) response and the only provisional response the device has
received for the call is the 100 Trying provisional response
(indicative of a home proxy server failure).
Enables the device to perform SIP re-registration upon TCP/TLS
connection failure.
[0] Disable (default)
[1] Enable
Defines the user name that is used in the From and To headers in SIP
REGISTER messages. If no value is specified (default) for this
parameter, the UserName parameter is used instead.
Note: This parameter is applicable only for single registration per device
(i.e., AuthenticationMode is set to 1). When the device registers each
channel separately (i.e., AuthenticationMode is set to 0), the user name
is set to the channel's phone number.
Determines the device's registration and authentication method.
[0] Per Endpoint = Registration and authentication is performed
separately for each endpoint/B-channel. This is typically used for
FXS interfaces, where each endpoint registers (and authenticates)
separately with its user name and password.
[1] Per Gateway = (Default) Single registration and authentication for
the entire device. This is typically used for FXO interfaces and digital
modules.
658
Mediant 600 & Mediant 1000
Description
Document #: LTRT-83313

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mediant 1000

Table of Contents