Fxo Gateway Configuration - AudioCodes Mediant 600 User Manual

User's Manual

27.15.6 FXO Gateway Configuration

The procedure below describes how to configure the FXO interface (to which the PBX is
directly connected).

To configure the FXO interface:
1. In the Trunk Group Table page (see Configuring Trunk Group Table on page 291,
assign the phone numbers 200 to 204 to the device's FXO endpoints.
2. In the Automatic Dialing page, enter the phone numbers of the FXS device in the
'Destination Phone Number' fields. When a ringing signal is detected at Port #1, the
FXO device automatically dials the number '100'.
3. In the Outbound IP Routing Table page, enter 10 in the 'Destination Phone Prefix'
field, and the IP address of the FXS device (10.1.10.3) in the field 'IP Address'.
4. In the FXO Settings page (see 'Configuring FXO Parameters' on page 392), set the
parameter 'Dialing Mode' to Two Stages (IsTwoStageDial = 1).
Version 6.6
Figure 27-13: Assigning Phone Numbers to FXO Ports
Figure 27-14: FXO Automatic Dialing Configuration
Figure 27-15: FXO Tel-to-IP Routing Configuration
413
27. Analog Gateway
Mediant 600 & Mediant 1000