Voice Mail Parameters - AudioCodes Mediant 600 User Manual

Parameter
Web: Enable Special Digits
EMS: Use '#' For Dial Termination
[IsSpecialDigits]

13.12.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For detailed information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Web/EMS: Voice Mail Interface
[VoiceMailInterface]
Web: Enable VoiceMail URI
EMS: Enable VMURI
[EnableVMURI]
SIP User's Manual
Determines whether the asterisk (*) and pound (#) digits can
be used in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection
(refer to the parameter UseDigitForSpecialDTMF).
(Default.)

[1] Enable = Allows '*' and '#' for telephone numbers
dialed by a user or for the endpoint telephone number.
Note: These symbols can always be used as the first digit of
a dialed number even if you disable this parameter.
Table 13-40: Voice Mail Parameters
Enables the device's Voice Mail application and
determines the communication method used between the
PBX and the device.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = For ISDN

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and
deactivate messages include Siemens Manufacturer
Specific Information (MSI)

[7] IP2IP = The device's IP2IP application is used for
interworking between an IP Voice Mail server and the
device. This is implemented for sending unsolicited SIP
NOTIFY messages received from the Voice Mail server
to an IP Group (configured using the parameter
NotificationIPGroupID).

[8] ETSI = Euro ISDN, according to ETS 300 745-1
V1.2.4, section 9.5.1.1. Enables MWI interworking from
IP to Tel, typically used for BRI phones.
Note: To enable voice mail per Trunk Group, you can use
a Tel Profile ID (using the TelProfile parameter) that is
configured with voice mail interface enabled. This
eliminates the phenomenon of call delay on Trunks not
implementing voice mail when voice mail is enabled using
this global parameter.
Enables or disables the interworking of target and cause
for redirection from Tel to IP and vice versa, according to
RFC 4468.

[0] Disable = Disable (default).

[1] Enable = Enable
Upon receipt of an ISDN Setup message with Redirect
610
Mediant 600 & Mediant 1000
Description
Description
Document #: LTRT-83308