AudioCodes Mediant 600 User Manual page 220

Notes:

To configure Proxy Sets:
1. Open the Proxy Sets Table page (Configuration tab > VoIP menu > Control
Network submenu > Proxy Sets Table).
2. From the 'Proxy Set ID' drop-down list, select an ID for the desired group.
3. Configure the Proxy parameters, as required. For a description of the parameters, see
the table below.
4. Click Submit.
5. To save the changes to flash memory, see 'Saving Configuration' on page 494.
Parameter
Web: Proxy Set ID
EMS: Index
[ProxySet_Index]
User's Manual
•
Proxy Sets can be assigned only to Server-type IP Groups.
•
The Proxy Set table can also be configured using two complementary
tables:
- Proxy Set ID with IP addresses: Table ini file parameter, ProxyIP.
- Attributes for the Proxy Set: Table ini file parameter, ProxySet.
Figure 16-1: Proxy Sets Table Page
Proxy Sets Table Parameters
Defines the Proxy Set identification number.
The valid value is 0 to 31. Proxy Set ID 0 is used as the default Proxy Set.
Note: Although not recommended, you can use both default Proxy Set (ID
0) and IP Groups for call routing. For example, in the Trunk Group Settings
page (see Configuring Trunk Group Settings on page 293) you can
configure a Serving IP Group to where you want to route specific Trunk
Description
220
Mediant 600 & Mediant 1000
Document #: LTRT-83313