Creating An Nfas-Related Trunk Configuration - AudioCodes Mediant 600 User Manual

Voip media gateways analog & digital lines
Hide thumbs Also See for Mediant 600:
Table of Contents

Advertisement

User's Manual
For example, if four T1 trunks on a device are configured as a single NFAS group with
Primary and Backup T1 trunks that is used with a DMS-100 switch, the following
parameters should be used:
NFASGroupNumber_0 = 1
NFASGroupNumber_1 = 1
NFASGroupNumber_2 = 1
NFASGroupNumber_3 = 1
DchConfig_0 = 0
DchConfig_1 = 1
DchConfig_2 = 2
DchConfig_3 = 2
If there is no NFAS Backup trunk, the following configuration should be used:
ISDNNFASInterfaceID_0 = 0
ISDNNFASInterfaceID_1 = 2
ISDNNFASInterfaceID_2 = 3
ISDNNFASInterfaceID_3 = 4
ISDNIBehavior = 512
;ISDNNFASInterfaceID coniguration above
NFASGroupNumber_0 = 1
NFASGroupNumber_1 = 1
NFASGroupNumber_2 = 1
NFASGroupNumber_3 = 1
DchConfig_0 = 0
DchConfig_1 = 2
DchConfig_2 = 2
DchConfig_3 = 2

21.6.3 Creating an NFAS-Related Trunk Configuration

The procedures for creating and deleting an NFAS group must be performed in the correct
order, as described below.
To create an NFAS Group:
1.
If there's a backup ('secondary') trunk for this group, it must be configured first.
2.
Configure the primary trunk before configuring any NFAS ('slave') trunk.
3.
Configure NFAS ('slave') trunks.
To stop / delete an NFAS Group:
1.
Stop or delete (by setting ProtocolType to 0, i.e., 'None') all NFAS ('slave') trunks.
2.
Stop or delete (by setting ProtocolType to 0, i.e., 'None') the backup trunk if a backup
trunk exists.
3.
Stop or delete (by setting ProtocolType to 0, i.e., 'None') the primary trunk.
Notes:
Version 6.6
;Primary T1 trunk
;Backup T1 trunk
;B-Channel NFAS trunk
;B-channel NFAS trunk
;This parameter should be added because of
;Primary T1 trunk
;B-Channel NFAS trunk
;B-Channel NFAS trunk
;B-channel NFAS trunk
All trunks in the group must be configured with the same values for trunk
parameters TerminationSide, ProtocolType, FramingMethod, and
LineCode.
After stopping or deleting the backup trunk, delete the group and then
reconfigure it.
287
21. Digital PSTN
Mediant 600 & Mediant 1000

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mediant 1000

Table of Contents