AudioCodes Mediant 600 User Manual page 511

User's Manual

User-defined routing tag (text)
Note:
The example configuration below assumes a scenario where multiple prefixes exist for
local and long distance calls:

To use Dial Plan file routing tags:
1. Load an ini file to the device that selects Dial Plan index (e.g., 1) for routing tags, as
shown below:
IP2TelTaggingDestDialPlanIndex = 0
2. Define the external Dial Plan file with two routing tags (as shown below):
•
"LOCL" - for local calls
•
"LONG" - for long distance calls
[ PLAN1 ]
42520[3-5],0,LOCL
425207,0,LOCL
42529,0,LOCL
425200,0,LONG
425100,0,LONG
For example, if an incoming IP call to destination prefix 425203 is received, the device
adds the prefix tag "LOCL" as specified in the Dial Plan file, resulting in the number
"LOCL425203".
3. Assign the different tag prefixes to different Trunk Groups in the Inbound IP Routing
Table (Configuration tab > VoIP menu > GW and IP to IP > Routing > IP to Trunk
Group Routing):
•
The Dest. Phone Prefix' field is set to the value "LOCL" and this rule is assigned
to a local Trunk Group (e.g. Trunk Group ID 1).
•
The Dest. Phone Prefix' field is set to the value "LONG" and this rule is assigned
to a long distance Trunk Group (e.g. Trunk Group ID 2).
Figure 38-1: Configuring Dial Plan File Label for IP-to-Tel Routing
The above routing rules are configured to be performed before manipulation
(described in the step below).
4. Configure manipulation in the Destination Phone Number Manipulation Table for IP to
Tel Calls table (Configuration tab > VoIP menu > GW and IP to IP submenu >
Manipulations submenu > Dest Number IP->Tel) for removing the first four
characters of the called party number "tag" (in our example, "LOCL" and "LONG"):
•
The Destination Prefix' field is set to the value "LOCL" and the 'Stripped Digits
From Left' field is set to '4'.
Version 6.6
Dial Plan Prefix Tags are not applicable to FXS and FXO interfaces.
511
38. Software Upgrade
Mediant 600 & Mediant 1000