AudioCodes Mediant 600 User Manual page 809

User's Manual
Parameter
Tel2IP]
Web: Use EndPoint Number
As Calling Number IP2Tel
EMS: Use EP Number As
Calling Number IP to Tel
[UseEPNumAsCallingNum
IP2Tel]
Web: Tel2IP Default
Redirect Reason
[Tel2IPDefaultRedirectRea
son]
Web: Redirect Number SIP
to TEL
EMS: Set IP To Tel Redirect
Screening Indicator
[SetIp2TelRedirectScreeni
ngInd]
Web: Set IP-to-TEL
Redirect Reason
[SetIp2TelRedirectReason
]
Version 6.6

[1] Enable
For example, if the incoming calling party number in the Q.931 Setup
message is "12345" and the B-channel number is 17, then the outgoing
INVITE From header is set to "17" instead of "12345".
Note: When enabled, this feature is applied before routing and
manipulation on the source number.
Enables the use of the B-channel number as the calling party number
(sent in the Q.931 Setup message) instead of the number received in
the From header of the INVITE, for IP-to-Tel calls.

[0] Disable (default)

[1] Enable
For example, if the incoming INVITE From header contains "12345" and
the destined B-channel number is 17, then the outgoing calling party
number in the Q.931 Setup message is set to "17" instead of "12345".
Note: When enabled, this feature is applied after routing and
manipulation on the source number (i.e., just before sending to the Tel
side).
Determines the default redirect reason for Tel-to-IP calls when no
redirect reason (or "unknown") exists in the received Q931 ISDN Setup
message. The device includes this default redirect reason in the SIP
History-Info header of the outgoing INVITE.
If a redirect reason exists in the received Setup message, this
parameter is ignored and the device sends the INVITE message with
the reason according to the received Setup message. If this parameter
is not configured (-1), the outgoing INVITE is sent with the redirect
reason as received in the Setup message (if none or "unknown" reason,
then without a reason).

[-1] Not Configured = (Default) Received redirect reason is not
changed

[1] Busy = Call forwarding busy

[2] No Reply = Call forwarding no reply

[9] DTE Out of Order = Call forwarding DTE out of order

[10] Deflection = Call deflection

[15] Systematic/Unconditional = Call forward unconditional
Determines the value of the Redirect Number screening indicator in
ISDN Setup messages.

[-1] Not Configured (default)

[0] User Provided

[1] User Passed

[2] User Failed

[3] Network Provided
Note: This parameter is applicable only to digital PSTN interfaces
(ISDN).
Defines the redirect reason for IP-to-Tel calls. If redirect (diversion)
information is received from the IP, the redirect reason is set to the
value of this parameter before the device sends it on to the Tel.

[-1] Not Configured (default)

[0] Unkown

[1] Busy
809
52. Configuration Parameters Reference
Description
Mediant 600 & Mediant 1000