Voice Mail Parameters - AudioCodes Mediant 800B User Manual

Parameter
Inter Digit Timeout for Overlap
Dialing
time-btwn-dial-digs
[TimeBetweenDigits]
Enable Special Digits
special-digits
[IsSpecialDigits]

61.10.4 Voice Mail Parameters

The voice mail parameters are described in the table below. For more information on the
Voice Mail application, refer to the CPE Configuration Guide for Voice Mail.
Parameter
Voice Mail Interface
vm-interface
[VoiceMailInterface]
User's Manual
scenarios occur:

Maximum number of digits is dialed

Interdigit Timeout (TimeBetweenDigits) expires

Pound (#) key is pressed

Digit map pattern is matched
Analog: Defines the time (in seconds) that the device waits
between digits that are dialed by the user.
ISDN overlap dialing: Defines the time (in seconds) that the device
waits between digits that are received from the PSTN or IP during
overlap dialing.
When this inter-digit timeout expires, the device uses the collected
digits to dial the called destination number.
The valid range is 1 to 10. The default is 4.
Determines whether the asterisk (*) and pound (#) digits can be
used in DTMF.

[0] Disable = Use '*' or '#' to terminate number collection (refer
to the parameter UseDigitForSpecialDTMF). (Default.)

[1] Enable = Allows '*' and '#' for telephone numbers dialed by a
user or for the endpoint telephone number.
Notes:

The symbols can always be used as the first digit of a dialed
number even if you disable the parameter.

The parameter is applicable only to FXS and FXO interfaces.
Table 61-42: Voice Mail Parameters
Enables the device's Voice Mail application and determines
the communication method between the device and PBX.

[0] None (default)

[1] DTMF

[2] SMDI

[3] QSIG

[4] SETUP Only = Applicable only to ISDN.

[5] MATRA/AASTRA QSIG

[6] QSIG SIEMENS = QSIG MWI activate and deactivate
messages include Siemens Manufacturer Specific
Information (MSI)

[8] ETSI = Euro ISDN, according to ETS 300 745-1
V1.2.4, section 9.5.1.1. Enables MWI interworking from
IP to Tel, typically used for BRI phones.

[9] NI2= ISDN PRI trunks set to NI-2. This is used for
interworking the SIP Message Waiting Indication (MWI)
NOTIFY message to ISDN PRI NI-2 Message Waiting
Notification (MWN) that is sent in the ISDN Facility IE
1028
Mediant 800B Gateway and E- SBC
Description
Description
Document #: LTRT-10296