Restoring Factory Defaults; Restoring Defaults Using Cli; Restoring Defaults Using Hardware Reset Button - AudioCodes Mediant 600 User Manual

User's Manual
41

Restoring Factory Defaults

You can restore the device's configuration to factory defaults using one of the following
methods:

CLI (see 'Restoring Defaults using CLI' on page 537)

Hardware reset pinhole button (see Restoring Defaults using Hardware Reset Button
on page 537)

Loading an empty ini file (see 'Restoring Defaults using an ini File' on page 538)
41.1

Restoring Defaults using CLI

The device can be restored to factory defaults using CLI, as described in the procedure
below.

To restore factory defaults using CLI:
1. Access the CLI:
a. Connect the RS-232 serial port of the device to the communication port on your
computer. For serial cabling, refer to the Hardware Installation Manual.
b. Establish serial communication with the device using a serial communication
program (such as HyperTerminal
settings:
♦
♦
♦
♦
♦
2. At the CLI prompt, type the following command to access the configuration mode, and
then press Enter:
# conf
3. At the prompt, type the following command to reset the device to default settings, and
then press Enter:
# RestoreFactorySettings
41.2

Restoring Defaults using Hardware Reset Button

The device's hardware reset pinhole button can be used to reset the device to default
settings.

To restore default settings using the hardware reset pinhole button:

With a paper clip or any other similar pointed object, press and hold down the reset
pinhole button, located on the CPU module for at least 12 seconds (but no more than
25 seconds).
Version 6.6
Baud Rate: 115,200 bps
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
TM
) with the following communication port
537
41. Restoring Factory Defaults
Mediant 600 & Mediant 1000