Install A Processor Module Or Processor Filler Module - Oracle SPARC T7-4 Service Manual

Install a Processor Module or Processor Filler Module

b.
c.
If you have removed a processor filler module as part of a server upgrade,
■
return to
If you have removed a processor module or processor filler module to
■
prepare the server for installation, return to
SPARC T7-4 Server Installation
Related Information
"Processor Module Components" on page 19
■
"Processor Module LEDs" on page 59
■
"Server Upgrade Process" on page 56
■
"Determine Which Processor Module Is Faulty" on page 60
■
"Servicing DIMMs" on page 69
■
"Install a Processor Module or Processor Filler Module" on page 64
■
"Verify a Processor Module" on page 67
■
Install a Processor Module or Processor Filler Module
Processor modules are cold-service components that can be replaced only by qualified
service personnel. For the location of the processor modules, see
(Service)" on page
Caution -
"Disconnect Power Cords" on page
Caution -
discharge. This discharge can cause failure of server components.
1. Ensure the power cords are disconnected.
See "Disconnect Power Cords" on page
64 SPARC T7-4 Server Service Manual • May 2017
Install the DIMMs into the new processor module.
See "Install a DIMM" on page
Install the processor module.
See "Install a Processor Module or Processor Filler Module" on page
"Server Upgrade Process" on page
14.
You must disconnect the power cords before servicing this component. See
This procedure requires that you handle components that are sensitive to electrostatic
80.
56.
"Preparing for Installation" in
Guide.
53.
53.
64.
"Front Panel Components