Install A Pcie Card Carrier - Oracle SPARC T7-4 Service Manual

Install a PCIe Card Carrier

Install a PCIe Card Carrier
Caution -
discharge. This discharge can cause failure of server components.
Note -
The server must either be powered off, or booted into the Oracle Solaris OS.
Insert the PCIe card carrier into the card cage until it stops.
1.
Caution -
2. Close the PCIe carrier handle.
Rotate the handle up until it latches into place.
3. Reconnect the cables to the PCIe card.
4. Determine your next step:
If you replaced or installed a PCIe card in a server that is running (that is, if
■
you hot-serviced the PCIe card), go to
180 SPARC T7-4 Server Service Manual • May 2017
This procedure requires that you handle components that are sensitive to electrostatic
Installing PCIe card carriers while the server is at the OpenBoot prompt is not supported.
Do not press on the PCIe back panel, or force the PCIe card carrier into the card cage.
Step 5.