Oracle SPARC T7-4 Service Manual page 81

Prepare the system for service.
■
See "Preparing for Service" on page
Remove the processor module. Place the processor module on an ESD-
■
protect work surface.
See "Remove a Processor Module or Processor Filler Module" on page
Consider your next steps.
2.
If you are replacing a faulty DIMM, ensure that you have removed the faulty
■
DIMM.
See "Identifying Faulty DIMMs" on page
See "Remove a DIMM" on page
If you are adding DIMMs to a half-populated processor module:
■
Ensure you have the correct DIMMs for your server. See
DIMMs" on page
If you are populating a new processor module:
■
Ensure you have the correct DIMMs for your server. See
Configurations" on page
3. Unpack the replacement DIMMs and place them on an antistatic mat.
4. Ensure that the ejector tabs on the connector that will receive the DIMM are in
the open position.
Align the DIMM notch with the key in the connector.
5.
43.
74.
78.
71.
69.
Install a DIMM
60.
"Identifying
"Understanding DIMM
Servicing DIMMs 81