Connect The Nvme Cables; Verify A Nvme Switch Card - Oracle SPARC T7-4 Service Manual
Hide thumbs
Also See for SPARC T7-4:
- Installation manual (90 pages) ,
- Safety and compliance manual (106 pages)
Table of Contents
Advertisement
Connect the NVMe Cables
1.
Plug the two NVMe data cables into the connectors on the NVMe switch card.
2.
Install the main module.
See
"Install the Main Module" on page
Verify a NVMe Switch Card
1.
Use the Oracle ILOM fault management shell to determine if the replacement
NVMe switch card is shown as enabled or disabled:
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
105.
Servicing NVMe Switch Cards
Connect the NVMe Cables
117
Advertisement
Table of Contents
Need help?
Do you have a question about the SPARC T7-4 and is the answer not in the manual?
Questions and answers