Oracle SPARC T7-4 Service Manual page 199

3. Start the faultmagmt shell.
-> start SP/faultmgmt/shell
Are you sure you want to start the faultmgmt shell (y/n)? y
faultmgmtsp>
4.
Use the fmadm faulty command to determine if the server is operating normally.
If a fault was detected, see
■
If no faults were detected, then the rear chassis subassembly has been replaced successfully.
■
No further action is required.
Related Information
"Detecting and Managing Faults" on page 25
■
"Rear I/O Module LEDs" on page 183
■
"Remove the Rear Chassis Subassembly" on page 194
■
"Install the Rear Chassis Subassembly" on page 197
■
"Diagnostics Process" on page
Servicing the Rear Chassis Subassembly
Verify the Rear Chassis Subassembly
26.
199